Home lighting > Domino LED > System equipments
RGB CONTROL UNITS
The customers create eye-catching lighting scenarios by using RGB versions of Domino LED fittings, which are designed to be controlled by professional electronic devices.
- RGB controller (code LZ-A0120) can feed at constant current and pilot up to a maximum of 30 fixed colour LEDs (10 red + 10 green + 10 blue) or 10 decorative RGB LEDs. The unit is pre-programmed with 16 lighting scenarios and 5 rotation speeds. The scenario and the speed of rotation can be selected by dip-switches on the controller's body. The control unit is provided with a push button input for control of the lighting cycles (press and hold down for ON/OFF, press briefly to interrupt and re-start the cycle at a given point in the lighting cycle). The control unit is compatible only with constant current input and cannot be used with on-board DMX RGB Simplex fittings.
- RGB DMX master controller (code LZ-A0200) shodul be used together with RGB fittings working with Simplex system. The RGB DMX light fittings are separately fed by one or more constant tension power supplies (provided that the negative 24VDC wires are always connected together) and have two independent DMX inputs for the connection to a single remote RGB DMX master controller, that allows to set and control the 32 fixed colours settings or the RGB loop for all fittings in synchronicity. On-board DMX Simplex RGB fittings are connected together by DMX wirings (in-and-out connections) along a single DMX circuit via twisted and shielded cables, with the RGB DMX master controller at the beginning (controlled by a simple push button) and a termination resistor of 120 Ohm 1/2W at the end. Without proper splitters or signal repeaters (available on request), up to 32 fittings could be connected together in a single DMX line. The maximum distance from the RGB DMX master controller to the last connected fitting could reach up to 300 m.
- RGB DMX slave controller is usually integrated within each RGB DMX Simplex fitting's body. Where not possible due to the small size of the fitting, the slave controller is external and placed next to the fixture. Slave controllers can be also separately ordered (code LZ-A0210) for complex compositions of decorative RGB LEDs fittings.