newsletter subscription
OPALE
12.09.2012

Something new!
Home automation  > Home Automation  > System equipments
Other Components

 

Power supply modules, wiring... BPT's product range is completed by a host of articles that improve and increase their efficiency and performance.

 

Download





Articles

Devices and software

OH/SW PROGRAMMING SOFTWARE Software and programming software. Used for the programming and personalisation of all the devices and component parameters for the system and for the creation and personalisation of the graphic operation interface of the terminal
MH/SW-PROGRAMMING SW Programming software and system configuration. Used for programming by means of OH/GW Gateway and personalisation of all the devices and component parameters the system as well as being for the creation and personalisation of the graphic interface for the operation of the terminal

GSM communicator

OH/GSM-230V GSM MODULE GSM phone communicator. Allows remote control and alert functions through the sending and receiving of an SMSmessage (max 10): can be controlled scenarios (max 16) and thermal areas (max 20) and technical alerts received (max 6). The switch is perfectly compatible with the Brahms B2 burglar alarm system. The power supply unit is provided with the OH/GSM switch and you can connect to a battery buffer* with 12 V OH/B008 (code 6790-0600), that allows it to operate, even in the absence of network voltage. Can be installed, with or without terminal covers, to the wall using the DINguide provided or in containers provided with DINguide (dimensions 4 DIN units). * battery buffer and SIM card not included in the pack
OH/B008-SEALED BATTERY Rechargeable battery for OH/GSM telephonic switch. Connected to the GSM phone module it allows the sending of system status messages even in the absence of network voltage.
OH/ANT-OPTIONAL ANTENNA Additional aerial for OH/GSM telephone communicator. Optional aerial (average length 3m) as an alternative the aerial supplied with the communicator. Use is recommended in the case in which it does not have a good reception/transmission signal compared to the installation point or assembly in metal containers.

Power supply

VAS/101 230V 50/60Hz AUXILIARY POWER SUPPLIER Audio entry system and/or supplementary power module for X1 systems. Plastic housing, for installation in electrical control panels (EN50022). Dimensions: 4 low-profile DIN modules. Protection rating IP30. Complete circuit board for power supply to entry panels and receivers (18 VDC - 1A max). Electronic circuit-breaker for protection against overloads/short-circuits. Terminals for control of riser bus. Powered by mains circuit 230 VAC 50/60 Hz.
OH/A.01-230V POWER SUPPLIER System Power supply. It is necessary for the system's operation, as it manages the power for all the system's devices (terminal control, area modules, relay modules, etc.) directly by bus (unpolarised twisted pair). 2 terminals available for connection to a battery buffer (optional). Can be installed, with or without terminal covers, to the wall using the DINguide provided or in boxes with DINguide (dimensions 6 DIN units).
OH/AS-230V POWER SUPPLIER Connected to the supplementary Power supply (OH/AS), maintains the bus network power supply, and therefore the Hoasis Plus system devices, for up to 10 hours
VAS/100MH-230V POWER SUPPLIER MITHO terminal power supply, 18 V DC, 4 DIN modules
OH/B065-SEALED BATTERY Rechargeable battery. Connected to the supplementary Power supply (OH/AS), maintains the bus network power supply, and therefore the Hoasis Plus system devices, for up to 10 hours

Wires

NH-C1D-CABLE BPT bus wire. It is used to connect all the input/output system components devices. Twisted pair, insulation cable 750 V.
NH-CAUSB USB RS232 CABLE ADAP. USB - RS232 adapter cable
NH-K422 CONVERTITORE RS232-422 Converter RS232-422
Conditions of use | Credits | Privacy Policy | General conditions of purchase
©2013 BPT S.p.A. a Socio unico - P.IVA 00180540270